Insights · guide

How many battery packs does a full-day VR activation need?

Drafted with Insight · edited by The WE ARE VR team

development

A dead headset is an empty seat.

Battery planning often happens while the equipment cases are already being packed. I wrote this because our queue and throughput calculations assume every planned headset remains available.

What's the problem?

A headset marked as having two hours of battery life may give you less during an activation. Your application, display brightness, passthrough mode, tracking and room temperature all affect runtime.

Charging labels can mislead too. A battery may support fast charging, but your cable, charger or overloaded multi-plug may slow it down. Test the complete setup you will use on site.

The common mistake is multiplying event hours by headset count. That tells you how many battery-hours you need, but not how many physical packs can rotate through charging.

You need four numbers:

  • Operating hours: the time between doors opening and the final session.
  • Usable runtime: how long one tested battery lasts in your actual experience.
  • Charging time: how long that battery takes to return to full charge.
  • Spare margin: extra packs for faults, slow charging and human error.

Use a conservative runtime. If a pack lasts 140 minutes in testing, planning around two hours gives the team breathing room.

What's the solution?

Start with the number of battery uses each headset needs:

uses per headset = operating hours ÷ usable runtime, rounded up

Then calculate how many packs are needed to keep a charging rotation alive:

cycling packs per headset = 1 + charging time ÷ runtime, rounded up

Use the smaller of those two results. A short event may finish before any pack needs to return from charging. A long event depends on packs cycling back into service.

Now multiply by the number of active headsets and add your spare margin:

total packs = headsets × packs per headset + spares

Consider a Braamfontein activation with four standalone headsets. It runs for eight hours. Each external battery pack gives two usable hours and needs three hours to recharge.

Each headset needs four battery uses across the day: eight divided by two. A continuous rotation needs three packs per headset: one in use, plus two covering the three-hour charging period.

That gives us twelve working packs across four headsets. A 20% spare margin adds three packs after rounding up, so the equipment plan calls for fifteen charged packs.

Label them by headset and rotation, such as H1-A, H1-B and H1-C. Record each swap on a paper sheet or shared phone note. Otherwise, someone will put a half-charged pack back into the ready case (usually during the busiest hour).

This calculation assumes your charging station can recharge every pack on schedule. Test all charger ports under load. For headsets with built-in batteries, treat a spare headset as the swappable powered unit and use the same method.

What's next?

  1. Run your experience continuously and measure one battery from full to your chosen safety level.
  2. Time a full recharge using the exact chargers, cables and multi-plugs going to the venue.
  3. Build a labelled rotation sheet, then add at least 20% spare capacity.

Share your battery sheet with the Jozi XR community, or ask us to check the maths.

The WE ARE VR team