Insights · guide
How to clean a VR headset between public users
Drafted with Insight · edited by The WE ARE VR team
development

Clean each headset in the same order, using separate cloths for lenses and skin-contact surfaces.
What's the problem?
A public VR headset collects sweat, skin oil, dust and fingerprints quickly. Johannesburg heat can make the facial interface especially damp during busy activations.
A rushed wipe often moves that grime around. It may also damage the headset. Household cleaners, paper towels and sprayed disinfectant can scratch lenses, weaken adhesives or strip protective coatings.
The facial interface is the removable section resting against the user's face. It needs different treatment from the lenses. Straps and controllers also need attention because users touch them while adjusting the headset.
Cleaning and disinfecting are separate jobs. Cleaning removes visible dirt. Disinfecting uses an approved product to reduce germs. A disinfectant needs contact time, meaning the surface must stay wet for the period printed on its label.
Before an event, check the headset maker's cleaning instructions. If a product is not approved for that material, do not use it. Alcohol may be suitable for some hard surfaces but harmful to lenses, foam and certain coatings.
What's the solution?
Use one fixed order and prepare a small cleaning station. You need a clean microfibre lens cloth, compatible surface wipes, spare facial interfaces and a container for used parts.
First, pause the session and switch off the headset. Disconnect charging cables and remove batteries where the design allows it. Wash or sanitise your hands before touching the lenses.
Clean the lenses first. Use a dry microfibre lens cloth and wipe gently from the centre outwards. Do not use disinfectant, alcohol, window cleaner or paper tissue. Never spray liquid onto the headset. A tiny droplet can reach a sensor or collect behind a lens.
Next, remove the facial interface if possible. Put a used washable interface into the marked container. Fit a clean, dry spare before the next user. For wipeable interfaces, clean away visible residue, then apply a compatible disinfectant for its full contact time. Let the surface dry completely.
Wipe the straps after the interface. Fabric straps may hold moisture and usually need washing and drying between sessions rather than a quick wipe. Replace them with a dry spare if they are damp. Hard plastic straps can be cleaned with a compatible wipe.
Finish with the controllers. Wipe the grips, triggers, buttons and wrist straps without flooding gaps. Avoid forcing liquid around thumbsticks or battery covers. Clean any shared headphones or adjustment knobs at the same time.
Use different cloths for lenses and body surfaces. A colour system helps: blue for lenses and green for everything users touch. Keep dirty cloths away from clean spares. (Mystery cloth roulette is a poor maintenance system.)
At a Jozi demo, assign one person to reset and clean equipment during busy periods. A completed headset goes into a clearly marked ready area. Used headsets stay in a separate queue. This simple split prevents someone from handing out a headset halfway through cleaning.
What's next?
- Check the cleaning instructions for every headset model in your fleet.
- Pack two labelled cloth colours and enough spare facial interfaces for one session.
- Practise the full reset, cleaning and drying routine before your next public demo.
Share your cleaning setup with the Jozi XR community, or ask us about a stubborn equipment problem.
The WE ARE VR team
