Insights · guide

How to estimate visitor throughput before a VR event

Drafted with Insight · edited by The WE ARE VR team

development

I would rather promise 140 completed sessions than apologise to 180 people.

We wrote this because visitor capacity often appears late in VR event planning. A quick throughput estimate helps producers, hosts and clients agree on a realistic guest number before the headsets reach the venue.

What's the problem?

A VR activation can look busy while completing fewer sessions than planned. The usual mistake is counting only the experience itself.

A five-minute build does not create a five-minute visitor slot. Someone must fit the headset, explain the controls, clean the face interface, reset the app and solve small problems. At a Johannesburg event, you may also lose time to late venue access, staff breaks, Wi-Fi trouble or a device that needs restarting.

The useful number is completed visitors, not people who joined the queue. (Queues are honest accountants.)

If you overestimate throughput, the queue grows and staff begin rushing guests. Some visitors leave without trying the work. If you underestimate it, you may hire extra headsets and crew that spend the day idle.

What's the solution?

Use one simple cycle:

cycle time = session time + changeover time

Then calculate:

maximum visitors = operating minutes ÷ cycle time × working headsets

Round down each headset's cycles before multiplying. A partial final slot cannot host a complete visitor.

Imagine a six-hour activation in Braamfontein. The VR experience lasts six minutes. Fitting, cleaning and resetting take two minutes, so each cycle takes eight minutes. You have four working headsets.

Six hours gives you 360 operating minutes. Each headset can complete 45 cycles. Four headsets can therefore finish 180 visitors in perfect conditions.

Perfect conditions rarely attend events.

I would plan around 80 per cent of that maximum, which gives 144 completed visitors. The remaining time absorbs toilet breaks, tricky fittings, app restarts and guests who need extra guidance. This is a planning allowance, not a law. Test your real setup and adjust it.

Keep briefing outside the headset cycle where possible. One host can explain controls to the next guests while current sessions run. Mark headset positions, prepare spare face interfaces and give each operator the same reset checklist. Removing one minute from every cycle adds up across a long day.

Also separate opening hours from operating hours. A venue booked from 09:00 to 17:00 does not provide eight hours of sessions if setup, a client speech and pack-down happen inside that window.

Put the calculation in your quote or event plan. State the session length, changeover assumption, headset count, operating window and buffered visitor target. The client can then see what must change if they ask for another hundred guests.

What's next?

  1. Time five full cycles with real people, including fitting, cleaning and reset.
  2. Calculate maximum capacity, then set a lower working target for interruptions.
  3. Compare the target with registrations and add timed slots if demand is higher.

Share your throughput calculation or ask us to check the assumptions.

The WE ARE VR team